Sharing Ideas

DCW Singapore: opportunities for Data Centre energy savings in tropical regions

Carel’s recent participation at “ Data Center World ” (DCW) Asia in Singapore was a great opportunity to meet some of the industry’s leading players in the southeast Asian area, addressing issues relating to data centre cooling in this region specifically and throughout Asia in general. This part of the world is experiencing strong economic growth, and with this comes a considerable...
Leggi di più A riguardo di DCW Singapore: opportunities for Data Centre energy savings in tropical regions »

Looking for alternative refrigerants to R-410A @ Heat Pump Summit in Nuremberg

Late 2017. “What is the replacement refrigerant for R-410A” is the question that perhaps more than any other is being asked in the HVAC industry. This is a consequence of other factors, such as: how much will R410A cost in the next semester ? Will it continue to be so difficult to source as has been the case for the last few months? Personally, I tried to find a response by participating...
Leggi di più A riguardo di Looking for alternative refrigerants to R-410A @ Heat Pump Summit in Nuremberg »

ATMOsphere Ibérica: how to cool when it’s really hot?

With an outdoor temperature of 26°C on 24 October, it could be said that the weather in Madrid was in line with the main focus of the first ATMOsphere Ibérica event: the challenges of natural refrigerants in warm climates. “Climatic conditions in Spain, Portugal and Latin American make the transition to natural refrigerants, in particular CO 2 , more difficult”, stated Alvaro de Oña, the...
Leggi di più A riguardo di ATMOsphere Ibérica: how to cool when it’s really hot? »

How can I choose the right humidification system for a paint booth?

This is the third and final discussion on paint booth applications. If you haven’t read the previous ones yet, please don’t forget to check them out! Today I’m going to talk about the best humidification solution for this specific application.  First of all, there is no one overall best solution, rather it depends on the requirements of each individual installation. A good...
Leggi di più A riguardo di How can I choose the right humidification system for a paint booth? »

Why does humidity need to be controlled in the printing industry?

Paper is a hygroscopic material that tends to reach a condition of equilibrium with the temperature-humidity conditions of the surrounding environment. Any swings in temperature and humidity can cause dimensional variations and loss of paper flatness . These phenomena are well-known to those who work in the printing industry as, if not appropriately controlled, they can...
Leggi di più A riguardo di Why does humidity need to be controlled in the printing industry? »

Relative humidity inside paint booths: what causes deviations from optimum conditions?

Paint booths are closed, air-conditioned spaces in which the ambient conditions are kept at the ideal values to ensure both a high quality finish of the coated surfaces and safety of the personnel working inside . Temperature, humidity and cleanliness of the air are ensured by an appropriate ventilation system . The conventional solution is an “all outside air” ventilation...
Leggi di più A riguardo di Relative humidity inside paint booths: what causes deviations from optimum conditions? »

How will commercial refrigeration develop in the future?

Undoubtedly, the expansion of commercial refrigeration is likely to continue due to the growing importance of food preservation . The food chain from “ field to fork ” must be able to guarantee food quality and safety , and above all for fresh products with a short shelf-life this can only be ensured by low temperature transport and storage, so as to prevent bacterial growth: indeed, ...
Leggi di più A riguardo di How will commercial refrigeration develop in the future? »

Eureka Roadshow Italy

On September 15, 2017, the Eureka Roadshow Italy , organised by EPEE and EVIA, with Centro Studi Galileo as its partner and CAREL and ZIEHL-ABEGG as sponsors , was held at the nh Laguna Palace Hotel in Mestre (Venice). The purpose of the event was to share the conclusions of Eureka 2016 (The Hague, 13/12/2016) with an audience of manufacturers, industry associations, consultants,...
Leggi di più A riguardo di Eureka Roadshow Italy »

The Future of HVAC 2017 by AIRAH

The Future of HVAC Conference , held over the past 5 years, has become the must-attend conference of the year. Industry leaders explore the advances, ideas, and innovations that are driving our industry’s future. The discussions encompass not only new HVAC technologies and materials, but advances in future design processes, HVAC and smart grids, net-zero buildings, big data, and...
Leggi di più A riguardo di The Future of HVAC 2017 by AIRAH »

Why does the printing industry require humidity control?

In order to ensure an efficient process and excellent and consistent quality of the printed product, the temperature and humidity in places designed for the storage and printing of paper and cardboard needs to be controlled appropriately. What are the effects on paper? The hygroscopic nature of paper Paper is a hygroscopic material that tends to reach a condition of...
Leggi di più A riguardo di Why does the printing industry require humidity control? »
Risultati 1 - 10 su 44.
Articoli per pagina 10
di 5

Topics

To find out more

 

 

Bloggers

Enrico Boscaro
post: 3
Data: 23/11/17
Biagio Lamanna
post: 4
Data: 16/11/17
Miriam Solana Ciprés
post: 13
Data: 09/11/17
Andrea Pagan
post: 3
Data: 02/11/17
Sofia Coin
post: 2
Data: 26/10/17
Luigi Nalini
post: 1
Data: 12/10/17
Raul Simonetti
post: 5
Data: 05/10/17
Anthony Harrigan
post: 1
Data: 28/09/17
Serena Ometto
post: 2
Data: 24/08/17
Roberto Sandano
post: 1
Data: 06/07/17
Andrea Oscar Frisiero
post: 3
Data: 15/06/17
Tommaso Ferrarese
post: 1
Data: 25/05/17
Carlo Bertelé
post: 1
Data: 18/05/17
Nicola Coccato
post: 1
Data: 13/04/17
Valerio Nalini
post: 3
Data: 06/04/17